Manufacturer Part #
MIC5014 Series 10 mA 30 V Low-Cost High or Low-Side MOSFET Driver - SOIC-8
|Standard Pkg:|| |
Product Variant Information section
2500 per Reel
Description of Change:Release to production of listed Micrel MOSFET Driver product type manufactured with the BCDM process technology to Microchip Fab.Pre Change:Fabricated at Micrel fabrication site (San Jose, CA, USA) using 6 inch wafers.Post Change:Fabricated at Microchip fabrication site using 8 inch wafers. Reason for Change:To improve productivity with the closure of the Micrel fab as part of the integration of Micrel and Microchip.
Description of Change:Qualification of new 7 inch plastic reel with new hub size for selected Micrel and Atmel products for 8mm and 12mm tape width. Pre Change: Hub size is 2.0 inchesPost Change: Hub size is 2.4 inchesReason for Change:To improve manufacturability by qualifying a new 7 inch plastic reel.Estimated First Ship Date:January 1, 2018NOTE: Please be advised that after the estimated first ship date customers may receive pre and post change parts.
|Configuration:||High or Low Side|
|No of Outputs:||Single|
|Peak Output Current:||10mA|
|Mounting Method:||Surface Mount|
Features & Applications
MIC5014YM TR and MIC5015 MOSFET drivers are designed for gate control of N-channel, enhancement-mode, power MOSFETs used as high-side or low-side switches. The MIC5014/5 can sustain an on-state output indefinitely. The MIC5014/5 operates from a 2.75 V to 30 V supply. In high-side configurations, the driver can control MOSFETs that switch loads of up to 30 V. In low-side configurations, with separate supplies, the maximum switched voltage is limited only by the MOSFET. The MIC5014/5 has a TTL compatible control input. The MIC5014 is noninverting while the MIC5015 is inverting.
The MIC5014/5 features an internal charge pump that can sustain a gate voltage greater than the available supply voltage. The driver is capable of turning on a logic-level MOSFET from a 2.75 V supply or a standard MOSFET from a 5 V supply. The gate-to-source output voltage is internally limited to approximately 15 V. The MIC5014/5 is protected against automotive load dump, reversed battery, and inductive load spikes of –20 V. The driver’s overvoltage shutdown feature turns off the external MOSFET at approximately 35V to protect the load against power supply excursions. The MIC5014 is an improved pin-for-pin compatible replacement in many MIC5011 applications. The MIC5014/5 is available in plastic 8-pin DIP and 8-pin SOIC pacakges.
- 2.75 V to 30 V operation.
- 100 µA maximum supply current (5 V supply).
- 15 µA typical off-state current.
- Internal charge pump.
- TTL compatible input.
- Withstands 60 V transient (load dump).
- Reverse battery protected to –20 V.
- Inductive spike protected to –20 V.
- Overvoltage shutdown at 35 V.
- Internal 15 V gate protection.
- Minimum external parts.
- Operates in high-side or low-side configurations.
- 1 µA control input pull-off.
- Inverting and noninverting versions.
- Automotive electrical load control.
- Battery-powered computer power management.
- Lamp control.
- Heater control.
- Motor control.
- Power bus switching.
2500 per Reel