Manufacturer Part #
Cypress CYPD3175-24LQXQT - Product Specification
Addendum to PCN220301 - Introduction of an additional assembly production site at UTAC Thai Limited (UTL 3), Chachoengsao, Thailand for select 24-Lead and 40-Lead QFN packages Reason: The purpose of this addendum to add BOM information as listed in below table and remove the 16 planned/forecasted affected parts. Expansion of assembly production to assure continuity of supply and enable flexible manufacturing. Description: Old & New see attached Impact of change: Based on the qualification performed, Infineon does not see any negative impact on quality, function and reliability. No change in fit and form. Time schedule: Final qualification report: Available First samples available: On request Intended start of delivery: 2022-04-24
Subject: USB Products Failure Analysis Policy Change Description of Change: Cypress is changing its policy for failure analysis of USB products to only accept units for failure analysis if the customer has successfully completed an ABA swap test1 for non-WLCSP/BGA packages or chip isolation test for WLCSP/BGA packages to confirm the failure was caused by the Cypress device. Additional information to replicate and solve the customer issue in a timely manner will be required. Benefit of Change: By implementing this policy change, Cypress will better be able to respond to the confirmed issues customers are observing. This policy change is required due to the large percentage of NTF (No Trouble Found) results on USB failure analysis cases. Approximate Implementation Date: This change will be implemented effective with the date of this notification.
Addendum to PIN195102 - Manufacturing Label and Packing Configuration Standardization Description of Change: The purpose of this addendum is to correct the date from January 20, 2019 to January 20, 2020, in the "3rd paragraph in the 'Description of Change' section. This notification is to inform customers that Cypress will be standardizing its manufacturing labels and tray/tube packing configuration. It may be recalled that the Cypress entity consolidation (following the merger with Spansion Corp) was announced via Product Information Notification PIN174801 in November 2017. As the next phase of the entity consolidation process, Cypress will be adapting a new manufacturing label format for all products and revising shipping configurations for select product shipped in trays and tubes.