Microchip | MIC4452YN

MIC4452YN and MIC4451 CMOS MOSFET drivers are tough, efficient, and easy to use. The MIC4451 is an inverting driver, while the MIC4452 is a non-inverting driver. Both versions are capable of 12 A (peak) output and can drive the largest MOSFETs with an improved safe operating margin.

The MIC4451/4452 accepts any logic input from 2.4 V to VS without external speed-up capacitors or resistor networks. Proprietary circuits allow the input to swing negative by as much as 5 V without damaging the part. Additional circuits protect against damage from electrostatic discharge. MIC4451/4452 drivers can replace three or more discrete components, reducing PCB area requirements, simplifying product design, and reducing assembly cost.

Modern Bipolar/CMOS/DMOS construction guarantees freedom from latch-up. The rail-to-rail swing capability of CMOS/DMOS insures adequate gate voltage to the MOSFET during power up/down sequencing. Since these devices are fabricated on a self-aligned process, they have very low crossover current, run cool, use little power, and are easy to drive.

Key Features:

• BiCMOS/DMOS Construction.
• Latch-Up Proof: Fully Isolated Process is Inherently Immune to Any Latch-up.
• Input Will Withstand Negative Swing of Up to 5 V.
• Matched Rise and Fall Times 25 ns.
• High Peak Output Current 12 A Peak.
• Wide Operating Range 4.5 V to 18 V.
• High Capacitive Load Drive 62,000 pF.
• Low Delay Time 30 ns Typ.
• Logic High Input for Any Voltage from 2.4 V to VS 
• Low Supply Current 450 µA With Logic 1 Input.
• Low Output Impedance 1.0 Ω.
• Output Voltage Swing to Within 25 mV of GND or VS.
• Low Equivalent Input Capacitance (typ) 7 pF.

Applications:

• Switch Mode Power Supplies.
• Motor Controls.
• Pulse Transformer Driver.
• Class-D Switching Amplifiers.
• Line Drivers.
• Driving MOSFET or IGBT Parallel Chip Modules.
• Local Power ON/OFF Switch.
• Pulse Generators.