Microchip | 25LC080B-I/SN

The 25LC080 (25XX080*) are 8 Kbit Serial Electrically Erasable PROMs. The memory is accessed via a simple Serial Peripheral Interface™ (SPI™) compatible serial bus. The bus signals required are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a Chip Select [CS(bar)] input.

Communication to the device can be paused via the hold pin [HOLD(bar)]. While the device is paused, transitions on its inputs will be ignored, with the exception of chip select, allowing the host to service higher priority interrupts.

Features:

• Low-power CMOS technology:
• Write current: 3 mA maximum
• Read current: 500 µA typical
• Standby current: 500 nA typical
• 1024 x 8-bit organization
• 16 byte page
• Write cycle time: 5 ms max.
• Self-timed erase and write cycles
• Block write protection:
• Protect none, 1/4, 1/2 or all of array
• Built-in write protection:
• Power-on/off data protection circuitry
• Write enable latch
• Write-protect pin
• Sequential read
• High reliability:
• Endurance: 1 M cycles
• Data retention: > 200 years
• ESD protection: > 4000 V
• 8-pin PDIP and SOIC (150 mil)
• Temperature ranges supported:
• Industrial (I): -40°C to +85°C